TSI - Setup: Charging the Modules

Home
Setup: Charging the Modules

Charging the Modules

Step 1

Connect the Modules to a power source. An ideal power source is 5 VDC, 2 Amp, 10 Watt. The green LED on the bottom of the module (directly above the charging port) will blink while charging. The provided USB cable can be used to make the connection. The Module can be charged in either on or off states.

Step 2

The green LED will change to solid green (not blinking) when charging is complete. The yellow LED indicates power is connected and can be ignored.

Note

It is recommended to charge the module when the battery life is at or below 10%, indicated by a red blinking LED located on the front. Yellow blinking LED means module battery life at or below 25%.