Pairing a Module to the Smart Station

Step 1.

Ensure that both the smart station and the module are powered on and are close to each other [< 2 m (6 ft)].

Step 2.

You should see a list of sensors that are within BLE (Bluetooth Low Energy) range.

NOTE:

If the app states ‘No sensor modules detected’, touch REFRESH. Touch the module you would like to connect to.

Step 3.

Verify that the connection was successful by confirming that a green check mark and module battery icon is present. Be patient, as this might take a few or more seconds.

Step 4.

Confirm that the LED on the front of the module changed from blinking blue to blinking green (once every 5 seconds).

Step 5.

Repeat the above steps to connect additional modules to the smart station. It is possible to connect up to five modules at any given time.

Step 6.

Touch DONE, when finished connecting all desired modules. If you would like to go back to the module connection screen or add another module in the future, touch the blue mesh icon (similar to a computer network icon) in the upper right corner.

NOTE:

It is not possible to connect the same module to two or more smart stations at the same time.

NOTE:

If a module is out of BLE range for roughly ~15 minutes or greater, it will power itself off to save the battery.

This website uses cookies

Account Invalid